Edmonton's Trusted
Sump Pump Repair company

The amount of time it takes to get hot water from a new water heater depends on the size and type of hot water heater. A properly and professionally installed gas hot water heater will provide hot water most quickly. An average 40-gallon heater will only take about 30 to 40 minutes to provide heat water, while you can expect hot water from a larger tank (80-gallons) in approximately 60 to 70 minutes. Electric hot water tanks, on the other hand, will take a little longer. For an average 40-gallon electric heater it will take about 60 to 80 minutes and for an 80-gallon tank about 2 hours.

If your drain is clogged with hair, baking soda can dissolve hair in a drain. 

To try this safe and easy method at home – first, pour a cup of baking soda down the drain. Then pour a cup of vinegar (white vinegar) down. Allow the mixture to sit for several minutes. Keep an eye out for bubbling in the drain (this is caused by the reaction between the baking soda and vinegar). Once the bubbling stops, wait a few more minutes then pour some hot water down the drain. Repeat until the clog is cleared. Keep at it, it can take a long time.

With a heavy-duty clog, you might need something more powerful. In this case, try snaking the drain, plunging it or calling a local Edmonton drain cleaning company to get the job done.

A sump pump is an appliance that is used to help prevent flooding in your home. If you’re in a flood zone and your basement floods regularly, if you have older plumbing, or if you just want to take a proactive step against flooding, then a sump pump installation is right for you. Sump pumps help prevent flood damage in your home by detecting increasing water pressure or water levels. If high levels are detected, the sump pump will pump water out of your basement and away from your home to a better location like a storm drain or a well.

Tankless water heaters are the most energy-efficient hot water systems on the market. In fact, tankless water heaters can be approximately 35% – 80% more efficient than traditional hot water tanks. 

Tankless hot water heaters can be powered by electricity or gas. However, gas-powered tankless heaters are more efficient. In addition to being more energy-efficient, tankless water heaters cost less to operate (up to 50% less than traditional hot water tanks) and last longer (up to double the lifetime).

The plumbing professionals at ProSolutions PHAC recommend the following high-efficiency tankless water heater:

• Noritz EZ111 (Gas Powered)

Please note: Although tankless water heaters are the most energy-efficient hot water system, they are not for everyone. Our guide to tankless water heaters can help you decide if a tankless heater is the best option for your home.

In colder climates, water inside the pipes can freeze. When water freezes, it expands, which can cause the pipe to crack or burst. This is especially common if the pipes are not properly insulated or if there are sudden drops in temperature.

There are several preventive measures you can take:

• Insulate your pipes, especially those in unheated areas like basements, garages, and crawl spaces.
• Keep your home’s thermostat set to a consistent temperature, even at night and when you’re away.
• Allow faucets to drip slightly during extremely cold spells to keep water flowing.
• Open cabinet doors under sinks to allow warm air to circulate around the pipes.

The best homemade drain cleaner is baking soda. Baking soda can be used along with vinegar or lemon juice to create a strong and effective homemade drain cleaner that is safe for your home’s pipes.

To unclog your drains using baking soda and vinegar or lemon juice, pour one cup of baking soda then one cup of white vinegar or lemon juice down the drain. Allow this to sit for an hour then pour down a few cups of boiling water. If this doesn’t work the first time, repeat as necessary.

If your homemade drain cleaner isn’t working, call an experienced provider of drain cleaning plumbers near you to take a look. A professional plumber will be able to determine what is causing the clogged drain and how to fix it.

It can cost anywhere from $3,500 to $5,500 to get a water softener installed in your home. This estimate includes the price of the unit as well as installation. The total cost will range depending on several factors including the type of water softener you choose, the softener’s capacity, the size of your home and the difficulty of the installation. In order to avoid unnecessary costs down the road, it’s important that you have your water softener installed by an expert. Water softener installation in Edmonton is ideal, especially if you are constantly having to deal with soap scum and limescale buildup or you want to increase the longevity of your household appliances that use water.