St. Albert's Trusted
Gas Line Installation company

Absolutely! ProSolutions Inc. specializes not only in repairing burst pipes but also in preventive measures. Our experienced technicians can inspect your plumbing system, identify potential problem areas, and provide solutions to prevent pipes from freezing and bursting.

The time it takes to repair a burst pipe can vary based on the location and severity of the break. A simple repair might take a few hours, while more complex situations could require several days. Water damage restoration, depending on the extent of the damage, can take anywhere from a few days to several weeks. It’s crucial to address water damage promptly to prevent mold growth and further structural issues.

Remember, in the event of a burst pipe, it’s essential to act quickly to minimize damage and ensure the safety of everyone in the home.

There are several preventive measures you can take:

• Insulate your pipes, especially those in unheated areas like basements, garages, and crawl spaces.
• Keep your home’s thermostat set to a consistent temperature, even at night and when you’re away.
• Allow faucets to drip slightly during extremely cold spells to keep water flowing.
• Open cabinet doors under sinks to allow warm air to circulate around the pipes.

Water softeners last about 10 to 20 years. The lifetime of your water softener will depend on several factors including the type of water softener and brand you buy, as well as the installation. Proper installation is important to ensure maximum effectiveness and lifetime. One of the many benefits of having a water softener installed in your home is that it will extend the lifetime of your other plumbing appliances. Hard water is tough on appliances like water heaters and laundry machines, as the minerals in the water wear away pipe sealants over time causing leaks and clogs. However, a water softener will remove excessive mineral content from all of the water, helping to protect your plumbing and appliances from unnecessary damage.

If your drain is clogged with hair, baking soda can dissolve hair in a drain. 

To try this safe and easy method at home – first, pour a cup of baking soda down the drain. Then pour a cup of vinegar (white vinegar) down. Allow the mixture to sit for several minutes. Keep an eye out for bubbling in the drain (this is caused by the reaction between the baking soda and vinegar). Once the bubbling stops, wait a few more minutes then pour some boiling water down the drain. Repeat until the clog is cleared. Keep at it, it can take a long time.

With a heavy-duty clog, you might need something more powerful. In this case, try snaking the drain, plunging it or calling a local Edmonton drain cleaning company to get the job done.

Sump pumps need annual maintenance. Like other appliances in your home, a sump pump should be maintained and serviced on a yearly basis. In some cases, more maintenance may be required. It is important to stay on top of sump pump maintenance in order to prevent a disaster. Oftentimes, homeowners will not notice that their sump pump isn’t working until it’s too late. Suddenly, when the sump pump is required, the homeowner discovers that it isn’t working as it should be. Many professional plumbing contractors provide Service Partner Plans that can help you properly maintain your appliances. An annual maintenance plan like this will ensure that your sump pump is always in top working condition.

The difference between a boiler and a hot water tank has to do with the way in which each uses the hot water that it produces.

Both boilers and hot water tanks take cool water, heat this water and then distribute it throughout a home via pipes. However, the water that is heated by a boiler is distributed throughout the home via pipes, radiators and radiant in-floor systems in order to heat it – to keep the rooms, floors, garage, etc. comfortable and warm.

On the other hand, a hot water tank heats water that is used for cooking and cleaning purposes – for showers, dishwashing, laundry, etc.

In colder climates, water inside the pipes can freeze. When water freezes, it expands, which can cause the pipe to crack or burst. This is especially common if the pipes are not properly insulated or if there are sudden drops in temperature.