Yes—especially if you want to reduce your energy bills, lower your carbon footprint, and get the most comfort from your system. Higher-efficiency ACs can also help increase the value of your home and extend the life of your system with fewer breakdowns.
Pro Tip: SEER2 is now becoming the new standard across Canada. Many newer AC models are already listed using only SEER2 rating—so if you’re comparing older and newer systems, make sure you’re looking at the same standard!
AC parts break down over time. However, an improperly maintained central air conditioning system will put pressure on every part of that system. A dirty filter that hasn’t been replaced, fans that are not cleaned, leaking refrigerant, exposed wires in the electrical box, ice build up on coils. These put pressure on the capacitors, sensors that track heat levels and thermostat readings and generally weaken the unit so it does not run efficiently and any part can break down.
The size of AC you need will depend on several factors.
For help finding the right size AC for your home, book your free home estimate! We will help you find the right size and the right unit for your needs. Our technician will complete a load calculation to determine what size AC you need. Factors like the size of your home, the local climate, the number of appliances you have, etc. will be taken into account.
Keep in mind, while you can have an AC unit that is too small you can also have a unit that is too big. An AC that is too small will not be able to cool your whole home and a unit that is too big will waste energy. In both scenarios, your utility bill will be more than necessary and you will likely be reducing the lifespan of the air conditioner! The size of AC you need is essential to your home comfort. ProSolutions can help you find the perfect air conditioner unit for your home and get it installed for the perfect Summer.
If your furnace blower is not working, there could be a couple of issues here, one more serious than the other. Firstly, it is important to understand how a furnace works. You can begin to understand this through a very simple principle. A furnace uses some type of fuel (i.e. electrical, oil, gas, etc) to heat a series of coils. What type of fuel your furnace uses for this combustion. This series of heated coils (called a heat exchanger) has a fan (called a blower motor) which blows your houses’ air over them and into your air ducts where it is dispersed throughout your house. This simple process, regardless of what type of fuel you use, is how your furnace is able to blow warm air into your home.
If you’re having any issues with your furnace blower not working. It can come down to the blower motor in the furnace may need replacing and that’s usually a job for the experts. A capacitor. If the capacitor is defective, the fan motor might be noisy, overheat, or not run at all. If the control board is defective, it might not send voltage to the blower motor. If the furnace is not getting power, check the furnace circuit breaker or fuse as this might also be an issue.
On the other hand, the unit may be clogged with dirt and dust and you may be able to fix that yourself but may likely need special attention to unclog the debris and dirt from the components.
In the end, there are several things that can lead to a furnace not blowing air. If you decide to try and repair an older unit and it requires more effort and costs incurred. It may just be more advantageous to replace it.
If you need help with your furnace issues, give us a call today!
Reasons your AC unit won’t run at all, sounds like an electrical problem. A fuse may have blown or circuit breaker tripped. If resetting those doesn’t solve the problem there may be an issue with the unit’s circuit board. In which case check with ProSolutions Inc. to give you a diagnosis.
Trust ProSolutions Inc.’s expertise and choose Ameristar Air Conditioning brand for a comfortable summer.
Replacing an old air conditioner involves more than just swapping out the unit. Several parts of your home’s cooling system may need to be inspected, repaired, or upgraded to ensure your new AC runs efficiently and reliably. This can include:
Ductwork: Is it properly sized, sealed, and in good condition?
Insulation & Windows: Poor insulation or drafty windows can affect performance.
Refrigerant Lines: Existing piping may need to be replaced or flushed, depending on the type of refrigerant.
Condensate Drainage: Proper drainage is crucial to avoid water damage.
Electrical Wiring: The wiring and breaker may need updating to meet current safety codes.
Grilles & Registers: These may need to be cleaned, repaired, or resized.
Filters & Coils: The furnace filter and evaporator coil should be inspected for cleanliness and wear.
Every home is different. That’s why a professional assessment from ProSolutions is the best way to determine exactly what’s needed for a proper air conditioning replacement in Edmonton’s climate.
If you find leaking water under the furnace, the drain line may be clogged with dirt, dust, and fungus growth.
You can try unplugging it with a wet-dry vac, but it’s better to let the experts at ProSolutions Inc. handle it. They can help you with AC repairs, including fixing leakages.
The cost to install an AC in Edmonton will depend on the unit you choose to purchase, as well as the unit you are replacing and the condition of your home and ductwork. The cost to purchase a unit and have it installed by a professional air conditioning services provider can be anywhere from $5,000 to $10,000 or more.
Simple, low-end air conditioning units will cost less to install. If you would like a high-efficiency AC that is ultra-quiet, you can expect to pay more. It’s important to note, however, that energy-efficient models can help you save on utility bills.
It may look cheaper to purchase an AC on it’s own, however finding a handyman to install and maintain means higher costs and stress in the long run. Many companies do not install AC units not supplied by them (some manufacturer’s even require it!)
ProSolutions offers free home estimates, professional recommendations, expert installations, and dedicated yearly maintenance with our ProCooling memberships. All in one!
With temperatures rising nationwide alongside our everchanging Albertan weather, we want to stay comfortable and cool while keeping our bills as low as possible—and the best way to do that is by making sure your air conditioning systems are working …
Read MoreWhat do Canada’s new AC refrigerant regulations mean for you? If you’re anything like us, you like your home to be your sanctuary—comfortable even during a heatwave. That’s why it’s important to know what’s happening with Canada’s new refrigerant regulations …
Read MoreAir conditioning is 100% worth it in Stony Plain. The summers in Stony Plain get very hot and an efficient, properly calibrated AC provides a comfortable indoor space. As a result, many Stony Plain homeowners have installed air conditioning in recent years. Now, more than 60% of homes in Alberta use AC during the summer months.
A central AC is your best bet for efficient and reliable cooling if you want to escape the heat this summer.
Thinking of installing a new AC in your Stony Plain home? You may require a permit for your new air conditioner. Don’t worry, ProSolutions can help. Our experienced Stony Plain AC company will be there every step of the way - from helping you choose the perfect AC to filing for permits, and more. Plus, our local technicians will guarantee that your new air conditioner is perfectly calibrated so you can enjoy optimal home comfort, even on the hottest days.
It costs approximately $4,500 to $9,500+ to install air conditioning in Stony Plain. The total cost for a new AC depends on several factors, such as:
An air conditioner with a high-efficiency rating and many advanced features will cost the most upfront. However, this type of AC will also help you save on energy costs. Therefore, it is recommended that you purchase the most efficient air conditioning unit you can afford.
ProSolutions offers a wide range of AC brands at price points to fit all budgets.
A high-efficiency AC costs about $30-45 per month to operate in Stony Plain. However, the less efficient your air conditioner is, the more it will cost to keep turned on. Compared to a high-efficiency AC, like a 16 SEER or higher, an inefficient unit can cost $100+ per month in electricity.
As you can see, buying a new air conditioner with a high-efficiency rating can help you save a significant amount in energy costs!
ProSolutions Plumbing, Heating & Air Conditioning doesn't just work in Edmonton. We also serve the surrounding communities, including:
